Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
leadership:roadmaps:2016_spring_semester:weatherbox_challenge:schedule [2016/01/24 00:22] zdorman created |
— (current) | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== Weatherbox Challenge Schedule ====== | ||
| - | |||
| - | ===== Early Stages ===== | ||
| - | * eagle tutorials | ||
| - | * soldering tutorials | ||
| - | * processor tutorials | ||
| - | * understand the importance of modular code | ||
| - | |||
| - | ===== Getting Individual Parts Working ===== | ||
| - | * get microprocessor working | ||
| - | * know how to reprogram it | ||
| - | * blink program | ||
| - | * get each sensor working (4 total) | ||
| - | * write individual firmware modules (use pre-existing libraries) | ||
| - | * test sensors on breadboard, verify firmware | ||
| - | * get XBee working | ||
| - | * write XBee modules (library) | ||
| - | * test on breadboard, verify firmware | ||
| - | * get charging circuit working | ||
| - | |||
| - | ===== Putting It All Together ===== | ||
| - | * wire everything together on breadboard | ||
| - | * verify hardware design | ||
| - | * integrate firmware modules into a main program | ||
| - | * verify firmware | ||
| - | * design pcb | ||
| - | * print pcb | ||
| - | * solder parts | ||
| - | * debug hardware | ||
| - | * load firmware and debug system | ||
| - | |||
| - | ===== Along the Way ===== | ||
| - | * create bill of materials | ||
| - | * create a power budget | ||
| - | * other analysis? | ||
| - | * presentations | ||
| - | * final report | ||