Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
user:kluong:feature_idea_-_onboard_xbee_diagnostics [2021/03/24 17:18] kluong [Feature Idea - Onboard XBee Diagnostics] |
user:kluong:feature_idea_-_onboard_xbee_diagnostics [2021/09/19 21:59] (current) |
||
|---|---|---|---|
| Line 15: | Line 15: | ||
| Some of the code would look like: | Some of the code would look like: | ||
| - | <code> | + | <code C++> |
| xbee_port.write("+++\r"); | xbee_port.write("+++\r"); | ||
| Line 31: | Line 31: | ||
| </code> | </code> | ||
| - | In the serial console, the user would see something like this: | + | In the serial console, the user would see something like this, after entering command mode and typing XBEE_DIAG: |
| <code> | <code> | ||
| Line 43: | Line 43: | ||
| </code> | </code> | ||
| - | Would be good to start basic. But it might be possible to check other things as well with AT command that could be worth exploring: | + | Would be good to start basic and extend the functionality as needed. But it might be possible to check other things as well with AT command that could be worth exploring: |
| * if the xbee is connected to a network at all | * if the xbee is connected to a network at all | ||
| * signal strength | * signal strength | ||
| * might be more here as well | * might be more here as well | ||