Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
week_6_-_february_24_2025 [2025/02/25 04:33] dfang created |
week_6_-_february_24_2025 [2025/02/27 00:05] (current) dfang [2/24/2025] |
||
|---|---|---|---|
| Line 2: | Line 2: | ||
| * Worked on Bare Arduino circuit | * Worked on Bare Arduino circuit | ||
| * Complications: Wires breaking, LEDs not working, missteps on circuit building (wrong connections); was able to upload to Arduino IDE, but the LED would not blink. | * Complications: Wires breaking, LEDs not working, missteps on circuit building (wrong connections); was able to upload to Arduino IDE, but the LED would not blink. | ||
| - | * Next time: try to fix the blinking problem by tweaking wires and components, or replacing LEDs on breadboard. | + | * Next time: try to fix the blinking problem by tweaking wires and components, or replacing LEDs on breadboard (use multimeter to see if attiny is working). |
| + | |||
| + | ===== 2/26/2025 ====== | ||
| + | * Attempted to fix bare arduino circuit by replacing microcontroller twice | ||
| + | * Used BME 280 sensor to see if it was flowing through. | ||