wind_sensor:meeting_minutes_mar_17_2017

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
wind_sensor:meeting_minutes_mar_17_2017 [2017/03/18 01:13]
mwu [Ultrasonic Wind Sensor]
wind_sensor:meeting_minutes_mar_17_2017 [2021/09/19 21:59] (current)
Line 3: Line 3:
 =====Acoustic Wind Sensor===== =====Acoustic Wind Sensor=====
   * Updates:   * Updates:
-    * +    * Soldered new microphones to tests 
 +    * Began testing algorithm using the new microphones 
 +      * recalculated coefficients for mapping wind speed to real time process output 
 +      * calculated using single trials of 5 different wind speeds  
 +      * New microphones were tested on a breadboard 
 +      * Results are consistent - algorithm accurately determines wind speeds, but has fairly poor precision
   * To Do:   * To Do:
-    * +    * De-solder microphones from pcb and see if that fixes the original problem
 =====Ultrasonic Wind Sensor===== =====Ultrasonic Wind Sensor=====
   * Updates:   * Updates:
Line 11: Line 16:
       * Using 1k samples, the results were pretty consistent (varies by around 1 microsecond). However, I noticed that the experiment was **very** sensitive to its surroundings. Even moving my hand around (about 2 feet away) was still enough to cause fluctuations in the results.       * Using 1k samples, the results were pretty consistent (varies by around 1 microsecond). However, I noticed that the experiment was **very** sensitive to its surroundings. Even moving my hand around (about 2 feet away) was still enough to cause fluctuations in the results.
       * The good news is that if I keep my hands still, the results are pretty consistent.       * The good news is that if I keep my hands still, the results are pretty consistent.
 +    * Constructed a 40kHz square wave using a 555 timer and plan to use that to drive the transducer emitter.
   * To Do:   * To Do:
     * Gather some data using our current experimental setup.     * Gather some data using our current experimental setup.
 +    * Start implementing amplifier with the transducers so the Teensy can control the emitter.
     * Look into using high speed ADC found here: https://​forum.pjrc.com/​threads/​25532-ADC-library-update-now-with-support-for-Teensy-3-1. Only use a limited bit precision to try and get the highest speed.     * Look into using high speed ADC found here: https://​forum.pjrc.com/​threads/​25532-ADC-library-update-now-with-support-for-Teensy-3-1. Only use a limited bit precision to try and get the highest speed.
     * Look into using thresholding to detect a wave, and then run some ADCs to determine the phase shift afterwards.     * Look into using thresholding to detect a wave, and then run some ADCs to determine the phase shift afterwards.
  
  • wind_sensor/meeting_minutes_mar_17_2017.1489799583.txt.gz
  • Last modified: 2021/09/19 21:59
  • (external edit)