* Desoldered wires
  * Research potential solar panels to purchase
  * Test to see if the solar panel works on gateway
  * Drained one of the batteries
  * Switched the board to male headers and changed the wires connected to the sp215 into female headers
  * When cutting the wires that are connected to the sp215, it was found that the colors of the wires didn't match.
  * For future purpose, Red is the signal, Black is the +5V, and the one with no sheathing is the ground. 
  * The reason why the battery stops sending signals despite having voltage is because the Arduino needs a minimum battery voltage of 3.3V in order to send signals.