=====Week 10=====
====Meeting Minutes March 21, 2017====

**attended: Isaiah, Kayla**

=== Updates ===
   * Slain the spaghetti monster
     * Replaced wires to make our board easier on the eyes
     * Doing so somehow fixed our problem. Sending and receiving now works without errors running on 3.3V
   * Able to send and receive packets from board to board
   * Added 3rd xbee, using one to send packet, one to route, and one to receive
     * Tried to add 4th xbee had problems sending and receiving packets

====Meeting Minutes March 23, 2017====

**attended: Isaiah, Kayla**

=== Updates ===
   * Updated gantt chart
     * Pushed back PCB design and fabrication due to changing focus on networking
     * Will attempt to finish schematic over spring break

===Notes===
   * Xbee computer to computer
     * Router to coordinator worked
     * coordinator to router did not work (coordinator sent packet to itself)
     * router to router did not work
   * Arduino to breadboard to computer
     * Arduino sends packet every 5 sec to breadboard
     * Breadboard receives packet, reads it, repackages, send to computer
     * Addresses of xbees are hard coded
     * Tested
       * Coordinator to router to router worked
       * Router to coordinator to router worked
       * Router to router to router worked
   * When setting PAN ID, make sure to refresh everything in the networking tab
   * Programming the arduino
     * Make sure correct arduino board is selected
     * Make sure correct port is selected
     * Make sure xbee shield is in Dline
   * Programming the breadboard
     * Make sure arduino pro or pro mini is selected (the one used to bootload the atmega)
     * Make sure correct port is selected
     * Make sure Tx and Rx pins aren't connected to anything
=== To Do ===
   * Make schematic for bumblebee box
   * Range testing
     * "Goal is Bang -> BAM" -Kaeo
     * Test "Bang -> Boom then Boom -> BAM" -Kaeo
     * Go through buildings and trees 
   * Start final paper