====== XBee + Arduino Sending Packet API Mode ======

===== Packet Sending: to Arduino XBee =====
Another short tutorial I followed to send packet to XBee Arduino:
http://www.desert-home.com/2012/10/using-xbee-library.html

{{:weatherbox:team_quasar:arduinoxbeereceiving.png?200|}}
===== Packet Sending: from Arduino XBee =====
You must download the XBee Library for Arduino!

==== Packet Receiving XBee ====
    *Connect the RX XBee to XCTU
    *Get the High and Low 64 Bit Address and write it down. It should most likely be 0 if you didn't change the original settings. This is different from your PAN ID.

==== Packet Sending XBee ====
    *Go to Arduino->File->Examples->XBee Library->Series2_Tx Example
    *You must download it as a binary file
    *Got to Arduino->Sketch-> Export File Binary
    *Check it compiles
    *Change the SH + SL Address of receiving XBee to the address you wrote down previously
    *Check it compiles and upload to the Arduino
    *Wire up board with Arduino and XBee (Make sure XBee TX goes to Arduino RX and XBee RX goes to Arduino TX)

==== Bringing two components together ====
    *Open XCTU and go to the Console Log screen
    *In Arduino, open the Serial Monitor
    *You should receive a packet in XCTU and the XBee Serial Monitor should say it received data

CONGRATS! You sent a packet :D

{{:weatherbox:team_quasar:arduinoxbeesending.png?200|}}