===== Verification Team Meeting - November 19, 2015 =====

Attended: May Chen, Kristie Lee, Christie Obatake

=====Notes=====
  * Apple sensor output pins (D - digital pin, A - analog pin)
      * SDA/SCL: current sensor, pressure sensor
          * JP3: pins 2 (A), 4 (A)
          * Current Sensor (not measuring for current)
              * Test power and GND
      * Pressure Sensor:
          * Figure out what to measure with SDA and SCL
      * Anemometer sensor (Not on the sensor board, but can still test if it’s powered/grounded)
          * JP3: pins 5 (D), 7 (D), 9 (D), 11 (A)
          * Test power and GND through Arduino ATmega since it is found there
      * Temperature sensor (two identical circuits for temp sensors)
          * JP3: pins 10 (D), 12 (D)
          * Figure out whether temperature or voltage is at Vout
      * Humidity sensor
          * JP3: 6 (D), 8 (D)
          * Where on temperature sensor is this measured? Or which one?
      * Power and GND
          * P3: pins 1 (A), 3 (A)
      * APOGEE solar irradiance
          * has jumper pins (JP4)
          * pin 1 = 5V, pin 3 = GND
      * GPS
          * pin 2 (VIN) = 5V, pin 3 = GND

=====Progress Check=====
  * Working out the logistics of verification board so that we can select parts


=====Tasks=====
  * Go over datasheets of Apple sensors and understand the pin outputs (see Notes for pin numbers)
  * Select parts
  * EAGLE layout

=====Completed=====
  * Decided that we will be using Verification Board to test sensors on Sensor Board
      * Examined Apple and Cranberry boards to see pin connections