reduce trace widths of miso, sck,mosi, and other data lines
delete the bottom ground plane and replace with vload, +5v_mcu, and 3.3v_xb planes
place load header and voltage regulators closer to components
don't need to route gnd trace for mcu because the entire top layer is ground
avoid running traces near the board perimeter (xbee_tx, prog_rx, prog_tx signals)
avoid unnecessary use of planes (n46 signal)
due to the pin pitch of the voltage regulator, the plane is narrowed significantly
rearrange components to maximize effective trace width from planes but also keeping planes compact
keep proper clearances from holes (C16 and U
![Fail: LaTeX compilation failed. $4 are too close)
* remove silkscreen from component values from board
* keep the text less cluttered and you can also refer to your schematic for component values
* Sensor Board:
* avoid sudden trace width reduction (gnd to u$](/lib/plugins/latex/images/renderfail.png)
6)
avoid creating additional planes on the top layer
remove gnd nubs (C27)
avoid using traces if planes can be utilized to connect signals