• Met with Dr. Kuh
• Met with Tryston on Wednesday to go over the progress
• Received housing files from Tryston
• 3D Printed one mounting piece
• Kyaw:
  • completed the updated version of Apple PCB design version 3.5.4
  • sent the PCB design to Tryston for checkup
• Makamae & Kenny
  • worked on soldering / debugging two previous Team Apple's board for deployment
  • began working on updating power budget
  • Made a checklist to organize the tasks we received

• Wired EN pin from GPS to digital pin 10 on Arduino
• Took out the two extra 0 ohms resistors from Solar Panel Power section
• Added 3×1 pin header for switch from charging circuit to regulators
• Took out extra 'Future Sensor'
• Switch RX and TX pins from XBEE to digital pins 2 and 9
• Put new 5V on/off switch sot 23-6 package

• Trouble figuring out the best way to find power consumption by the breakout boards on the Apple board

• CDR presentation in 2 weeks
• 0 Ohm resistors in the new design

Contributing authors:

Created by khien on 2016/10/29 01:22.