Attended: Mizpah, Sharmaine, Xiao

• Continue populating new PCB
• Continue debugging 2nd PCB: conclusion: solar chip is not soldered on properly
  1. since LEDs are not connected to ground
  2. solution: resolder solar chip

• resolder solar chip on the second board
• Finish up populating new board

Attended: Mizpah, Sharmaine, Xiao

• Resoldered solar chip
• Debug solar chip
  • resoldered but same problems as before
• tried running on the 3rd board. same problems as before
• leaking voltage?
  • Kenneth mentioned that their board before had problems with the switch as the switch was leaking voltage into the board.
  • we removed the switch and soldered on wires in its place on TX and RX

• Continue Debugging solar chip.
• Work with Firmware team to debug.

Contributing authors:

Created by sjavier on 2019/02/02 01:54.