Attended:Isaiah, Kayla, Rebecca

• Finished Proposal Presentation
• Updated gantt chart with slots for housing

• Figure out solution programmer not responding error
  • Use Capacitor connected to RTS pin of FTDI
  • Reset button
• Finalize design choices and start Schematic

Attended:Isaiah, Kayla, Rebecca

• Tried to fix programmer not responding problem
  • Swapped microcontroller, reburned bootloader
  • Programmer would go through reading but stop when writing. Changed out RX and TX wires which fixed the problem
  • After doing all that, it successful programmed without the use of the reset button.
  • Trying a second time (without reset) didn't work. Worked when using the reset button

Attended:Isaiah, Kayla, Rebecca

• Worked on adding three additional debugging leds, believe issue to be resistor value
• Researched parts for schematic

Contributing authors:

Created by iaribal on 2017/09/18 19:11.