* Use the Arduino IDE to program the device using the AVRISP MkII Programmer.
Use an ISP connector to attach the programmer to the Cranberry board.
Connections: MISO (1), VCC(2), SCK(3), MOSI(4), RESET(5), and GND(6).
Make sure that you have the right board selected: Arduino Pro or Mini (3.3V 8MHz) w/ Atmega328.
Note: Board must be powered using an external voltage source (e.g. battery or generator).
Burning the Bootloader
-
RESET (SS) - PIN 10
MOSI - PIN 11
MISO - PIN 12
SCK - PIN 13
VIN - 3V3
Authors
Contributing authors:
elum
Created by elum on 2018/09/18 01:39.