Table of Contents
Guava - Week of April 03, 2017
Updates
GPS
CDR Presentation
Reminders
Authors
Guava - Week of April 03, 2017
Updates
Worked on the powerpoint for the CDR
Need to work on schematic to put into powerpoint
Problems slides - time and parts
Gantt chart - talk about how were gonna make up or change our goals
Progress - Schematic - Parts Order/Research - Documentation - Final Paper
Worked on the test code for the BME280
Using the Arduino Uno and a breadboard to test the sensor until we can test it with our ATmega1284P
Using the I2C setup not the SPI yet
If we have time, we'll look into programming stardard pressure interface (SPI) (Serial Perpiheral Interface)
GPS
Tested GPS with Ardunio -
Works with just the power(5V), ground, RX, TX pins
tried to compare the collected data to the datasheet values but hard to decipher
Michael soldered new gps ultimate breakout
Messed up on the pins
But fixed it
Works
CDR Presentation
Almost finished just need to add schematic/board layout stuff
Polish it up
Assign slides - maybe 4 per person? idk
Prolly whoever wrote the slide should talk about the slide like we did last time
6 to 8 minutes means can talk slower / can talk less
Reminders
PDR → April 8th
496 Posters → April 27th
Back to Guava's Meeting Minutes
Authors
Contributing authors:
dkvilla
Created by
dkvilla
on 2017/04/04 04:05.