Attended:

• Kyaw
• Kenny
• Jaimie

* Kyaw finished the Board! :D

• He ran tests on the board with the sparkfun manufacture test
• Board is complete and is about 3*4 cm^2

* Jaimie and Kenny debugged the sensor/XBee/Arduino board with her compiled code

• The sensors are collecting correct data after fixing the variable type (i.e. long, unsigned float, etc.)
• Pins into ATMEGA328P are all corrected
• The XBees aren't working
  • Tried resetting but not doesn't want to reset! :(

* Fixed sensor variable type (i.e. long, unsigned float, etc.) * Fixed pins into ATMEGA328P for some sensors were incorrect * Fixed sensor connections to ATMEGA274P weren't grounded * XBees broken?? Not connecting at all :(

• Ryan said XBee could not be getting enough power from board… Look into this!
• Switch the XBee not resetting out

* Jaimie: Finish debugging integrated circuit * Kenny: Finish Bare Arduino * Kyaw: Make sure everything is ready for milling over break

Contributing authors:

Created by jobatake on 2016/03/16 21:10.