Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
training:using_xbee [2016/06/30 06:38] aobatake |
training:using_xbee [2021/09/19 21:59] (current) |
||
|---|---|---|---|
| Line 8: | Line 8: | ||
| 2 Xbee USB Explorer Board(with cables)\\ | 2 Xbee USB Explorer Board(with cables)\\ | ||
| 1 Arduino with Xbee Shield(or Bare Arduino with Xbee Breakout Board)\\ | 1 Arduino with Xbee Shield(or Bare Arduino with Xbee Breakout Board)\\ | ||
| - | Download XCTU and Xbee Arduino Library | + | Download [[https://www.digi.com/products/xbee-rf-solutions/xctu-software/xctu|XCTU]] and the [[https://github.com/andrewrapp/xbee-arduino|Xbee Arduino Library]]. |
| ==== Xbee Communication ==== | ==== Xbee Communication ==== | ||
| Line 26: | Line 26: | ||
| ==== Xbee & Arduino ==== | ==== Xbee & Arduino ==== | ||
| - | Go to the config page of your Router Xbee and note the High and Low Destination Address(Should be 0 by default, I change it to High:0, Low:FFFF).\\ | + | Go to the config page of your Router Xbee and note the High and Low Destination Address(Should be 0 by default, I change it to High:0, Low:FFFF). Make sure the High and Low Destination Addresses are the same for both XBees.\\ |
| Set up the Router Xbee on the Arduino shield and connect it to your computer. \\ | Set up the Router Xbee on the Arduino shield and connect it to your computer. \\ | ||