Week 3
Meeting Minutes September 18,2017
Attended:Isaiah, Kayla, Rebecca
- Finished Proposal Presentation
- Updated gantt chart with slots for housing
Plan for the week
- Figure out solution programmer not responding error
- Use Capacitor connected to RTS pin of FTDI
- Reset button
- Finalize design choices and start Schematic
Meeting Minutes September 20,2017
Attended:Isaiah, Kayla, Rebecca
- Tried to fix programmer not responding problem
- Swapped microcontroller, reburned bootloader
- Programmer would go through reading but stop when writing. Changed out RX and TX wires which fixed the problem
- After doing all that, it successful programmed without the use of the reset button.
- Trying a second time (without reset) didn't work. Worked when using the reset button
Meeting Minutes September 22,2017
Attended:Isaiah, Kayla, Rebecca
- Worked on adding three additional debugging leds, believe issue to be resistor value
- Researched parts for schematic
Authors
Contributing authors:
Created by iaribal on 2017/09/18 19:11.