Since the board is currently a mess of dangling wires there is a large possibility of losing connection. This was apparent when some of wires lost their solder and as such the wire needed more soldering. Also, from initial testing it seems like the RTC was not working as intended since it was actually sending signals to other components. This will be taken into effect when redoing the PCB design. We also started the slides for this Saturdays Preliminary Design Review.

Our first revision of Revision C IV is now out. We also finished setting up our slides for the following PDR. Finally we were able to start programming the board because we believed we finished troubleshooting the problems of the board.

Contributing authors:

Created by aereno on 2019/10/08 23:54.