Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
wind_sensor:meeting_minutes_apr_7_2017 [2017/04/08 12:17] mwu |
wind_sensor:meeting_minutes_apr_7_2017 [2021/09/19 21:59] (current) |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| =====Acoustic Wind Sensor===== | =====Acoustic Wind Sensor===== | ||
| * Updates: | * Updates: | ||
| + | * Created a perforated board to mimic the traces on the pcb | ||
| + | * Single microphone test results were consistent for all four microphones. | ||
| + | * Conducted single microphone tests for all four microphones using several different fans and iterations | ||
| + | * Devised a method of collecting raw analog data for four microphones | ||
| + | * Collected raw data for all four microphones under 9 different fan settings repeated 3 times each. | ||
| * To Do: | * To Do: | ||
| + | * Analyze raw data results and real time processed results from single-microphone peak detector | ||
| =====Ultrasonic Wind Sensor===== | =====Ultrasonic Wind Sensor===== | ||
| * Updates: | * Updates: | ||
| Line 10: | Line 16: | ||
| * Our results showed that at 40kHz, the transducer had an impedance of around 1.7k. Given that we are driving it with 3.3V, that puts our current draw to around 2mA, which is ten times smaller than our current limit. | * Our results showed that at 40kHz, the transducer had an impedance of around 1.7k. Given that we are driving it with 3.3V, that puts our current draw to around 2mA, which is ten times smaller than our current limit. | ||
| * Experimented with sending bursts of 41.67kHz pulses with the Teensy and observed the response on the oscilloscope. Below is the response of sending ten response, and below that is the response of sending a hundred pulses with a short delay. | * Experimented with sending bursts of 41.67kHz pulses with the Teensy and observed the response on the oscilloscope. Below is the response of sending ten response, and below that is the response of sending a hundred pulses with a short delay. | ||
| - | {{ :wind_sensor:pulse-response.jpg?direct&600 |}} | + | * {{ :wind_sensor:pulse-response.jpg?direct&600 |}} |
| - | {{ :wind_sensor:big-pulse-response.jpg?direct&600 |}} | + | * {{ :wind_sensor:big-pulse-response.jpg?direct&600 |}} |
| * We observed that the receiver takes some time to "ramp up" to a distinguishable voltage and it also takes some time to "ramp down" after the signals have passed. | * We observed that the receiver takes some time to "ramp up" to a distinguishable voltage and it also takes some time to "ramp down" after the signals have passed. | ||
| * This ramping up and down may cause some issues when we're trying to determine our propagation time. We shouldn't rely solely on our threshold detector to measure the propagation time since the "ramp up" part of the response is unreliable. | * This ramping up and down may cause some issues when we're trying to determine our propagation time. We shouldn't rely solely on our threshold detector to measure the propagation time since the "ramp up" part of the response is unreliable. | ||