Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision
Previous revision
problems_solutions_-_quartz_2025 [2025/04/08 02:43]
kanget created
problems_solutions_-_quartz_2025 [2025/04/15 03:47] (current)
hiro453 [PCB Layout] Added issues and solutions
Line 1: Line 1:
-======Minutes====== +======Problems & Solutions - Quartz 2025======
-  * Set up our wiki page and decided on team name\\  +
-  * Read and set up arduino piano\\ +
-  * Read and used the BME280 arduino module\\ +
-  * Started on proposal presentation slides\\ +
-Members Present: Kenneth and Ethan+
  
-====January 29 Update==== +====Kicad Tutorials==== 
-  * Finished project proposal slides +Problems: 
-  * Practiced presenting +  * Several of the connections in the Schematic Editor didn't have Netclasses 
-Members PresentKenneth ​and Ethan+  * Footprints were missing for a few of the parts of the Diya PCB 
 + 
 +Solutions: 
 +  * Make sure to thoroughly check connections to ensure that they have Netclasses 
 +  * For the parts that don't have Footprints, use similar ones with the same dimensions 
 + 
 +====Bare Arduino==== 
 +Problems: 
 +  * Blink program code was not uploading to Arduino, even after changing the breadboards,​ capacitors, microcontroller (three times), FTDI and as well as the entire setup 
 + 
 +Solutions:​ 
 +  * Change the components, since it could be due to a faulty one 
 +  * Check setup, making sure that the connections and circuit is correct by following the tutorial 
 +  * If still not working, restart from the beginning and try again 
 +  * Cross reference BME280 tutorial schematic to Bare Bone Arduino schematic 
 +====PCB Schematic==== 
 +Problems: 
 +  * Similar problems to Kicad tutorials, missing Netclasses and Footprints 
 + 
 +Solutions:​ 
 +  * Double check everything thoroughly to make sure all connections have Netclasses and that the Netclasses are correct 
 +  * For the components missing Footprints, replace with components with similar dimensions 
 +====PCB Layout==== 
 +Problems: 
 +  *Forgot about net classes and didn't assign them until after wiring the PCB. 
 + 
 +Solutions:​ 
 +  *Don't forget about setting up and assigning net classes before you start the PCB wiring. 
 + 
 +====Soldering==== 
 +Problems: 
 +  * 
 + 
 +Solutions:​ 
 +  * 
 +====Housing==== 
 +Problems: 
 +  * 
 + 
 +Solutions:​ 
 +  *
  • problems_solutions_-_quartz_2025.1744080234.txt.gz
  • Last modified: 2025/04/08 02:43
  • by kanget