Problems:

• Several of the connections in the Schematic Editor didn't have Netclasses
• Footprints were missing for a few of the parts of the Diya PCB

Solutions:

• Make sure to thoroughly check connections to ensure that they have Netclasses
• For the parts that don't have Footprints, use similar ones with the same dimensions

Problems:

• Blink program code was not uploading to Arduino, even after changing the breadboards, capacitors, microcontroller (three times), FTDI and as well as the entire setup

Solutions:

• Change the components, since it could be due to a faulty one
• Check setup, making sure that the connections and circuit is correct by following the tutorial
• If still not working, restart from the beginning and try again
• Cross reference BME280 tutorial schematic to Bare Bone Arduino schematic

Problems:

• Similar problems to Kicad tutorials, missing Netclasses and Footprints

Solutions:

• Double check everything thoroughly to make sure all connections have Netclasses and that the Netclasses are correct
• For the components missing Footprints, replace with components with similar dimensions

Problems:

• Forgot about net classes and didn't assign them until after wiring the PCB.

Solutions:

• Don't forget about setting up and assigning net classes before you start the PCB wiring.

Problems:

Solutions:

Problems:

Solutions:

Contributing authors:

Created by kanget on 2025/04/08 02:43.