Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
weatherbox:ant:meeting_minutes_september_15_2016 [2016/09/16 06:43] ssaepoo |
weatherbox:ant:meeting_minutes_september_15_2016 [2021/09/19 21:59] (current) |
||
|---|---|---|---|
| Line 2: | Line 2: | ||
| ===== Updates ===== | ===== Updates ===== | ||
| - | * Looked at Apple's schematic and determined which component is not needed: | + | * Understood how the power schematic works |
| - | * 5V Boost Converter, 5V ON/OFF Switch, 3.3V Voltage Regulator (Only 1 out of 2), and Sensors | + | * Determined that no sensors will be needed for this design since it's primary and only objective is to transmit and receive data simultaneously |
| - | * Read what types of mode the Xbee S2B has | + | * Determined that only one voltage regulator will be used instead of two |
| - | * | + | * 3.3V from Arduino Uno will power XBee S2B |
| + | | ||
| ===== Issues ====== | ===== Issues ====== | ||
| - | * Understanding how Xbees transmit/receive, communicate, operate, etc. | + | * None |
| - | * Not sure if Xbee can transmit/receive data packets simultaneously | + | |
| - | * Arduino doesn’t allow it | + | |
| - | * Understanding the power and sensor schematic connected to Xbee | + | |
| - | * Need to figure out how to use one Xbee for simultaneous communication | + | |
| - | * Sensors required for this design? (This box will act as a data transmit/received extension so not sure if sensors are needed) | + | |