Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
weatherbox:apple:meeting_minutes_november_3_2015 [2015/10/30 02:59] dkvilla |
weatherbox:apple:meeting_minutes_november_3_2015 [2021/09/19 21:59] (current) |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| =====Team Apple Meeting November 3, 2015===== | =====Team Apple Meeting November 3, 2015===== | ||
| - | **Attended: Kenny** | + | **Attended: Kaeo, Tyrin** |
| ===== Prequestions ===== | ===== Prequestions ===== | ||
| Line 6: | Line 7: | ||
| * How much did the past box cost? | * How much did the past box cost? | ||
| * Run the breakout box idea by him | * Run the breakout box idea by him | ||
| - | * Op-Amp Resistor - should we have the signal wire directly connected to the arduino. Or should we have the signal wire directly connected to the aruduino. Or should we have a resistor for reasons such as the pull-up resistor to an LED? | + | * Op-Amp Resistor - should we have the signal wire directly connected to the arduino. Or should we have the signal wire directly connected to the arduino. Or should we have a resistor for reasons such as the pull-up resistor to an LED? |
| + | * Is there any drawbacks to having detachable parts? | ||
| + | * What was the reasoning for having some parts directly soldered on and other parts detachable? | ||
| =====Updates===== | =====Updates===== | ||
| - | * | + | * Found a box for us to look at. |
| =====Problems===== | =====Problems===== | ||
| - | * The charging circuit | + | * The charging circuit's power consumption. |
| =====Reminders===== | =====Reminders===== | ||
| * CDR is coming up soon November 21st, 2015 | * CDR is coming up soon November 21st, 2015 | ||
| + | |||
| + | [[weatherbox:apple:start|Back to Apple Homepage]] | ||