Differences

This shows you the differences between two versions of the page.

--- weatherbox:apple:meeting_minutes_september_22_2015 [2015/10/27 03:34]
dkvilla created
+++ weatherbox:apple:meeting_minutes_september_22_2015 [2021/09/19 21:59] (current)
@@ Line 1: / Line 1: @@
-This is where the meeting minutes go
+====== Team Apple Minutes September 22, 2015 ======
+**Attended: Kaeo, Tyrin, Tryston, and Kenny**
+===== What We Learned =====
+  * We are the only group currently using the Arduino
+  * The red thing is a boost converter that boosts 3.7V to 5V
+  * Xbee runs at 3.3V. (There is a separate regulator to convert that.)
+  * There is a mystery humidity sensor.
+  * There's 2 humidity sensors. One is on the pressure sensor, but they work differently.
+  * Andy was mistaken about the power.
+    * It's not the power circuit. It's the fact that the system itself pulls too much juice.
+  * Battery fully charges around midday.
+  * The panel never directly powers the circuit. It only powers the charging circuit to charge the battery.
+  * Pressure and current sensor is connected to the I2C.
+  * GPS is used for having a lot of weather boxes set up, and you can tell which one/where the one we need is located. (Buoy Example)
+    * "Drop a box, and be able to find it in a sea of other boxes"
+  * Kenny is gonna make a core program for us to play around with the hardware we have something to test out.
+  * By the end of the week, we'll have a program for the arduino that can access all the different sensors and see if they work.
+  * Start talking to the other teams for advice about the troubles that we are having
+    * “Hey, were confused about this. Help?”
+    * By asking questions, this takes care of the overlap among the teams.
+    * Kennys always willing to help
+===== Issues =====
+  * N/A
+===== Reminders =====
+  * Block Diagram
+    * “If it gets too crowded, split it up.” -Kenny
+    * Power side and signal side.
+[[weatherbox:apple:start|Back to Apple Homepage]]