Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
weatherbox:apple:meeting_minutes_week_of_october_01_2023 [2023/10/05 22:39] snakahir |
weatherbox:apple:meeting_minutes_week_of_october_01_2023 [2023/10/05 22:40] (current) snakahir |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| * Test to see if the solar panel works on gateway | * Test to see if the solar panel works on gateway | ||
| * Drained one of the batteries | * Drained one of the batteries | ||
| - | * Switching the board to male headers and changing the wires connected to the sp215 into female headers | + | * Switched the board to male headers and changed the wires connected to the sp215 into female headers |
| * When cutting the wires that are connected to the sp215, it was found that the colors of the wires didn't match. | * When cutting the wires that are connected to the sp215, it was found that the colors of the wires didn't match. | ||
| * For future purpose, Red is the signal, Black is the +5V, and the one with no sheathing is the ground. | * For future purpose, Red is the signal, Black is the +5V, and the one with no sheathing is the ground. | ||
| - | * It was also found that the reason why the battery stops sending signals despite having voltage is because the Arduino needs a minimum battery voltage of 3.3V in order to send signals. | + | * The reason why the battery stops sending signals despite having voltage is because the Arduino needs a minimum battery voltage of 3.3V in order to send signals. |