Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
weatherbox:dragonfruit:cam_job [2016/02/24 23:11] garrettz |
weatherbox:dragonfruit:cam_job [2021/09/19 21:59] (current) |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== Steps ====== | + | ====== Processing a CAM Job for Manufacturing ====== |
| + | ===== Determine PCB Manufacturer ===== | ||
| + | |||
| + | Here is a list of recommended PCB manufacturers: | ||
| + | * Bay Area Circuits | ||
| + | * Advanced Circuits | ||
| + | * Osh Park | ||
| + | |||
| + | Research and determine if your design is machinable by the manufacturer you chose. You can enter their specifications into the Design Rule Check tool in Eagle. | ||
| ===== Generate Gerber Files ===== | ===== Generate Gerber Files ===== | ||
| ==== Process for a 2-layer board ==== | ==== Process for a 2-layer board ==== | ||
| Line 9: | Line 17: | ||
| * Top/bottom silkscreen | * Top/bottom silkscreen | ||
| * Drills/holes | * Drills/holes | ||
| + | - Click on "Process Job" to generate Gerber files | ||
| ==== Process for a 4-layer board ==== | ==== Process for a 4-layer board ==== | ||
| + | - Download the following files from Google Drive | ||
| + | * [[https://drive.google.com/a/hawaii.edu/folderview?id=0By3QY77qC22mdUNrZ2Y4dkJ5NkU&usp=sharing|4 Layer CAM job]] | ||
| + | - Run ULP drillcfg | ||
| + | - Run Excellon job | ||
| + | - Run E4 job | ||
| + | ===== Verify Gerber Files ===== | ||
| + | - Use the program Viewmate to check if the Gerber files were processed correctly | ||
| + | * [[http://www.pentalogix.com/viewmate.php| Viewmate]] | ||