Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
weatherbox:dragonfruit:cam_job [2016/02/24 23:31] garrettz |
weatherbox:dragonfruit:cam_job [2021/09/19 21:59] (current) |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== Steps ====== | + | ====== Processing a CAM Job for Manufacturing ====== |
| + | ===== Determine PCB Manufacturer ===== | ||
| + | |||
| + | Here is a list of recommended PCB manufacturers: | ||
| + | * Bay Area Circuits | ||
| + | * Advanced Circuits | ||
| + | * Osh Park | ||
| + | |||
| + | Research and determine if your design is machinable by the manufacturer you chose. You can enter their specifications into the Design Rule Check tool in Eagle. | ||
| ===== Generate Gerber Files ===== | ===== Generate Gerber Files ===== | ||
| ==== Process for a 2-layer board ==== | ==== Process for a 2-layer board ==== | ||
| Line 13: | Line 21: | ||
| ==== Process for a 4-layer board ==== | ==== Process for a 4-layer board ==== | ||
| - Download the following files from Google Drive | - Download the following files from Google Drive | ||
| - | - [[https://drive.google.com/a/hawaii.edu/folderview?id=0By3QY77qC22mdUNrZ2Y4dkJ5NkU&usp=sharing|4 Layer CAM job]] | + | * [[https://drive.google.com/a/hawaii.edu/folderview?id=0By3QY77qC22mdUNrZ2Y4dkJ5NkU&usp=sharing|4 Layer CAM job]] |
| - Run ULP drillcfg | - Run ULP drillcfg | ||
| - Run Excellon job | - Run Excellon job | ||
| - Run E4 job | - Run E4 job | ||
| - | + | ===== Verify Gerber Files ===== | |
| - | ==== Places to Order PCB's ==== | + | - Use the program Viewmate to check if the Gerber files were processed correctly |
| - | Here is a list of recommended PCB manufacturers: | + | * [[http://www.pentalogix.com/viewmate.php| Viewmate]] |
| - | * Bay Area Circuits | + | |
| - | * Advanced Circuits | + | |
| - | * Osh Park | + | |