Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
weatherbox:dragonfruit:pcb_rules [2016/02/24 20:52] garrettz |
weatherbox:dragonfruit:pcb_rules [2021/09/19 21:59] (current) |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== PCB Professional Design Rules ====== | ====== PCB Professional Design Rules ====== | ||
| These 28 Basic PCB design guidelines set out best practice to reduce the cost of your boards and to minimize the risk of errors arising during manufacture. | These 28 Basic PCB design guidelines set out best practice to reduce the cost of your boards and to minimize the risk of errors arising during manufacture. | ||
| + | |||
| High power boards have different rules especially in terms of spacing, traces size and power isolation. Manufacturers have different requirements; make sure you read their own guidelines before sending your design. Naming and file formats also vary depending on the manufacturers. | High power boards have different rules especially in terms of spacing, traces size and power isolation. Manufacturers have different requirements; make sure you read their own guidelines before sending your design. Naming and file formats also vary depending on the manufacturers. | ||
| - | //Taken from [[http://blog.upverter.com/post/102541308937/28pcb||Upverter Blog]]// | + | //Taken from [[http://blog.upverter.com/post/102541308937/28pcb|Upverter Blog]]// |
| ====PCB Layout==== | ====PCB Layout==== | ||
| - Create your board frame on a 0.05” grid. Make the lower left corner start at 0,0. | - Create your board frame on a 0.05” grid. Make the lower left corner start at 0,0. | ||