Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
weatherbox:team_nova:meeting_minutes_april_4_2016 [2016/04/06 00:24] tyamauchi created |
weatherbox:team_nova:meeting_minutes_april_4_2016 [2021/09/19 21:59] (current) |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| =====Updates===== | =====Updates===== | ||
| - | * Final Draft of housing complete | + | * Housing 3D printing complete |
| - | * Finished printing bottom of housing | + | * Need to drill bigger holes to fit solar panel |
| - | * Finished printing housing box | + | * Need to drill bigger hole for solar panel plug to fit |
| - | * Final touches completed on PCB | + | * Final PCB design complete |
| - | * PCB approved and ready to mill | + | * Sent files to Tyron |
| - | * changes to be made | + | * Waiting to mill |
| + | * Code complete (pending testing) | ||
| + | * Battery Voltage needs to be tested | ||
| + | * wrote code to process panel voltage (Need to be tested) | ||
| + | * Solar irradiance pins known | ||
| Line 14: | Line 18: | ||
| =====Problems===== | =====Problems===== | ||
| - | * XBee able to communicate one way but not both (Resolved within the week) | + | * Unsure if output is correct |
| - | * Ripped up breadboard to redo | + | * Housing |
| - | * Problem fixed with help of Jaimie | + | * hole for solar panel plug too small |
| - | * Xbee was not being powered | + | * solar panel doesn't quite fit onto housing |
| - | * Last minute changes to PCB | + | * need to drill bigger holes in micromouse |
| - | * Voltage divider connected to Atmega and Solar Panel diode to read panel voltage | + | |
| - | * Add DCIN component to Schematic and then to PCB | + | |
| - | * Last minute changes to housing | + | |
| - | * make port for solar panel cable to charging chip | + | |
| - | * account for battery | + | |
| =====Reminders===== | =====Reminders===== | ||
| - | * Figure out whats wrong with XBee (Resolved) | + | * Buy PVC and screws for mounting |
| + | * Design new bottom for housing | ||
| + | * Account for drop in voltage from diode | ||