Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
weatherbox:team_quasar:meeting_minutes_march_16_2016 [2016/03/16 21:10] jobatake created |
weatherbox:team_quasar:meeting_minutes_march_16_2016 [2021/09/19 21:59] (current) |
||
---|---|---|---|
Line 6: | Line 6: | ||
==== Updates ==== | ==== Updates ==== | ||
+ | * Kyaw finished the Board! :D | ||
+ | * He ran tests on the board with the sparkfun manufacture test | ||
+ | * Board is complete and is about 3*4 cm^2 | ||
+ | * Jaimie and Kenny debugged the sensor/XBee/Arduino board with her compiled code | ||
+ | * The sensors are collecting correct data after fixing the variable type (i.e. long, unsigned float, etc.) | ||
+ | * Pins into ATMEGA328P are all corrected | ||
+ | * The XBees aren't working | ||
+ | * Tried resetting but not doesn't want to reset! :( | ||
==== Problems ==== | ==== Problems ==== | ||
+ | * Fixed sensor variable type (i.e. long, unsigned float, etc.) | ||
+ | * Fixed pins into ATMEGA328P for some sensors were incorrect | ||
+ | * Fixed sensor connections to ATMEGA274P weren't grounded | ||
+ | * XBees broken?? Not connecting at all :( | ||
+ | * Ryan said XBee could not be getting enough power from board... Look into this! | ||
+ | * Switch the XBee not resetting out | ||
==== Reminders ==== | ==== Reminders ==== | ||
+ | * Jaimie: Finish debugging integrated circuit | ||
+ | * Kenny: Finish Bare Arduino | ||
+ | * Kyaw: Make sure everything is ready for milling over break |