Show pageOld revisionsBacklinksBack to top This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong. * Desoldered wires * Research potential solar panels to purchase * Test to see if the solar panel works on gateway * Drained one of the batteries * Switched the board to male headers and changed the wires connected to the sp215 into female headers * When cutting the wires that are connected to the sp215, it was found that the colors of the wires didn't match. * For future purpose, Red is the signal, Black is the +5V, and the one with no sheathing is the ground. * The reason why the battery stops sending signals despite having voltage is because the Arduino needs a minimum battery voltage of 3.3V in order to send signals. weatherbox/apple/meeting_minutes_week_of_october_01_2023.txt Last modified: 2023/10/05 22:40by snakahir