Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
weatherbox:dragonfruit:meeting_minutes_september_11_2017 [2017/09/13 21:53] khein |
weatherbox:dragonfruit:meeting_minutes_september_11_2017 [2021/09/19 21:59] (current) |
||
---|---|---|---|
Line 12: | Line 12: | ||
* We've figured out the why the board is reading "odd" solar test voltage. | * We've figured out the why the board is reading "odd" solar test voltage. | ||
* The output of the charging circuit is soldered to the VCC input of the board, which the solar test voltage is reading from | * The output of the charging circuit is soldered to the VCC input of the board, which the solar test voltage is reading from | ||
- | * As far as the board is concerned, the solar test voltage should be reading half of the voltage from the battery (voltage divider connection) | + | * As far as the board is concerned, the solar test voltage should be reading half of the voltage from the battery (voltage divider connection) |
* We've emailed Dr. Garmire about the roof top access. Waiting for his reply. | * We've emailed Dr. Garmire about the roof top access. Waiting for his reply. | ||
+ | Update: 9/15 | ||
+ | * Battery voltage reading from the solar test pin is actually correct | ||
+ | * The value is multiplied by 2 in the code when transmitted to the gateway | ||
+ | * Tested sensor data values: Humidity, Temp., Solar Irradiance, Pressure | ||
+ | * Ready to for deployment test next week | ||
+ | * We just need to find our solar panels | ||
==== Tasks ==== | ==== Tasks ==== | ||
* Have to test on roof to conclude about charging circuit (working properly or not) with or without the solar panel attached | * Have to test on roof to conclude about charging circuit (working properly or not) with or without the solar panel attached |