Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
weatherbox:hardware_design_requirements [2016/10/11 19:50] kluong [Hardware Design Requirements] |
weatherbox:hardware_design_requirements [2021/09/19 21:59] (current) |
||
|---|---|---|---|
| Line 7: | Line 7: | ||
| * Provide an in circuit programming interface | * Provide an in circuit programming interface | ||
| * Provide self-programming support through a UART interface | * Provide self-programming support through a UART interface | ||
| - | * Be able to be powered and operational without a battery | + | * The UART interface must be compatiable with the FTDI breakout boards supplied by adafruit and sparkfun |
| + | * Be able to be powered and operational without a battery - meaning the board must provide an external interface to be able to power the board. | ||
| * Platforms with an XBee transceiver must provide a LED linked to the RSSI pin | * Platforms with an XBee transceiver must provide a LED linked to the RSSI pin | ||
| + | * Provide a functional block diagram outlining functional modules down to the MCU level. | ||
| + | * Provide a circuit diagram | ||
| + | * Provide an equivalent circuit model(s) for all components | ||