Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
weatherbox:kiwi:start [2018/05/13 08:35] achen |
weatherbox:kiwi:start [2021/09/19 21:59] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Kiwi ====== | ====== Kiwi ====== | ||
==Team Members: Jason Chen, Alex Chen== | ==Team Members: Jason Chen, Alex Chen== | ||
+ | ==Mentor: Mark Cacal== | ||
====== Introduction ====== | ====== Introduction ====== | ||
Line 18: | Line 19: | ||
====== Software ====== | ====== Software ====== | ||
Our code can be found in our [[https://github.com/jason472/SCEL-Weatherbox | github]], which was based on previous teams codes. | Our code can be found in our [[https://github.com/jason472/SCEL-Weatherbox | github]], which was based on previous teams codes. | ||
+ | |||
+ | ====== Hardware ====== | ||
+ | {{:weatherbox:kiwi:final_block_diagram_296.png?linkonly|Block Diagram}} | ||
+ | |||
+ | {{:weatherbox:kiwi:reis_296_weatherbox_schematic_last_.png?linkonly|Reis 296 Weatherbox Schematic}} | ||
+ | * {{ :weatherbox:kiwi:schematic_power_layer.png?linkonly |Power and Voltage Regulators}} | ||
+ | * {{ :weatherbox:kiwi:schematic_sensor_layer_ftdi_xbee.png?linkonly |Sensors, FTDI, and XBEE}} | ||
+ | * {{ :weatherbox:kiwi:schematic_atmega328p.png?linkonly |ATMEGA328P}} | ||
+ | |||
+ | {{ :weatherbox:kiwi:pdb_last_.png?linkonly |Overall PCB design}} | ||
+ | * {{ :weatherbox:kiwi:pcb_5v_.png?linkonly |PCB design (Top Layer: 5V)}} | ||
+ | * {{ :weatherbox:kiwi:pcb_gnd_.png?linkonly |PCB design (Bottom Layer: GND)}} | ||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
====== Meeting Minutes ====== | ====== Meeting Minutes ====== |