Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
weatherbox:bumblebee:how_to_range_test [2021/03/07 21:50] lcorpuz |
weatherbox:bumblebee:how_to_range_test [2021/09/19 21:59] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ===Using the XCTU Program:=== | + | **=== Using the XCTU Program: ===** |
- Make sure everything is connected: wires, code is correct | - Make sure everything is connected: wires, code is correct | ||
- Make sure all Xbees recognize one another (close the plug(+) | - Make sure all Xbees recognize one another (close the plug(+) | ||
Line 34: | Line 34: | ||
LED on XBee should be on; not blinking? | LED on XBee should be on; not blinking? | ||
- | === Range Testing w/ PCBs === | + | **=== Range Testing w/ PCBs ===** |
* Connect solar charging chip and relay xbee onto the PCB board (we used v4.0) | * Connect solar charging chip and relay xbee onto the PCB board (we used v4.0) | ||
* Connect battery into the solar charging chip (Batt) | * Connect battery into the solar charging chip (Batt) |