Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
weatherbox:bumblebee:mesh_network [2021/04/03 20:41] lcorpuz |
weatherbox:bumblebee:mesh_network [2021/09/19 21:59] (current) |
||
---|---|---|---|
Line 27: | Line 27: | ||
**=== Testing the XBees Communications ===** | **=== Testing the XBees Communications ===** | ||
- | * Using the laptop containing the coordinator | + | * Using the laptop containing the coordinator (API 1 XBee or SENDER): |
- | * Using the laptop contained the router: | + | * Wirelessly connect to Relay_1 and Relay_2 |
- | * Open up XCTU program and discover the router XBee | + | * Place laptop at one end of hallway |
- | * | + | * Using the laptop contained the router (Relay_1): |
- | + | * Open up XCTU program | |
+ | * Place laptop in between SENDER and Relay_2: | ||
+ | * Using the laptop contained the second router (Relay_2): | ||
+ | * Start up XCTU | ||
+ | * Place laptop past Relay_1 | ||
+ | * After finishing the placement of the three XBees communicate from Relay_2 by creating packets | ||
+ | * Relay_1 should receive the packets as ASCII values | ||
+ | * SENDER should receive the packet as ASCII values and also the address of Relay_2 | ||
+ | * After verifying that all 3 Xbees are communicating start a range test with SENDER computer | ||
+ | * In range test, select sender address and Relay_2 address | ||
+ | * Increase distance as far as possible | ||
**=== Testing with PCB ===** | **=== Testing with PCB ===** | ||
- | + | * Place Relay_1 XBee on PCB | |
+ | * Connect PCB to battery | ||
+ | * Same configuration of XBees similar to above where starting from beginning it will be: Sender->Relay_1->Relay_2 | ||
+ | * Start by sending packets from Relay_2 and see if Sender is receiving packets | ||
+ | * Start range test with Sender computer | ||
+ | * Complete range test | ||
| | ||
References: | References: | ||