Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
weatherbox:bumblebee:week_10_-_march_21_2017 [2017/03/22 00:02]
kamano
weatherbox:bumblebee:week_10_-_march_21_2017 [2021/09/19 21:59] (current)
Line 1: Line 1:
-=====Week ​9=====+=====Week ​10=====
 ====Meeting Minutes March 21, 2017==== ====Meeting Minutes March 21, 2017====
  
Line 9: Line 9:
      * Doing so somehow fixed our problem. Sending and receiving now works without errors running on 3.3V      * Doing so somehow fixed our problem. Sending and receiving now works without errors running on 3.3V
    * Able to send and receive packets from board to board    * Able to send and receive packets from board to board
-   * Added 3rd xbee +   * Added 3rd xbee, using one to send packet, one to route, and one to receive 
 +     * Tried to add 4th xbee had problems sending and receiving packets 
 + 
 +====Meeting Minutes March 23, 2017==== 
 + 
 +**attended: Isaiah, Kayla** 
 + 
 +=== Updates === 
 +   * Updated gantt chart 
 +     * Pushed back PCB design and fabrication due to changing focus on networking 
 +     * Will attempt to finish schematic over spring break 
 + 
 +===Notes=== 
 +   * Xbee computer to computer 
 +     * Router to coordinator worked 
 +     * coordinator to router did not work (coordinator sent packet to itself) 
 +     * router to router did not work 
 +   * Arduino to breadboard to computer 
 +     * Arduino sends packet every 5 sec to breadboard 
 +     * Breadboard receives packet, reads it, repackages, send to computer 
 +     * Addresses of xbees are hard coded 
 +     * Tested 
 +       * Coordinator to router to router worked 
 +       * Router to coordinator to router worked 
 +       * Router to router to router worked 
 +   * When setting PAN ID, make sure to refresh everything in the networking tab 
 +   * Programming the arduino 
 +     * Make sure correct arduino board is selected 
 +     * Make sure correct port is selected 
 +     * Make sure xbee shield is in Dline 
 +   * Programming the breadboard 
 +     * Make sure arduino pro or pro mini is selected (the one used to bootload the atmega) 
 +     * Make sure correct port is selected 
 +     * Make sure Tx and Rx pins aren't connected to anything 
 +=== To Do === 
 +   * Make schematic for bumblebee box 
 +   * Range testing 
 +     * "Goal is Bang -> BAM" -Kaeo 
 +     * Test "Bang -> Boom then Boom -> BAM" -Kaeo 
 +     * Go through buildings and trees  
 +   * Start final paper
  • weatherbox/bumblebee/week_10_-_march_21_2017.1490140979.txt.gz
  • Last modified: 2021/09/19 21:59
  • (external edit)