Differences

This shows you the differences between two versions of the page.

--- weatherbox:bumblebee:week_10_-_march_21_2017 [2017/03/23 22:17]
kamano
+++ weatherbox:bumblebee:week_10_-_march_21_2017 [2021/09/19 21:59] (current)
@@ Line 18: / Line 18: @@
 === Updates ===
    * Updated gantt chart
-   *
+     * Pushed back PCB design and fabrication due to changing focus on networking
+     * Will attempt to finish schematic over spring break
+===Notes===
+   * Xbee computer to computer
+     * Router to coordinator worked
+     * coordinator to router did not work (coordinator sent packet to itself)
+     * router to router did not work
+   * Arduino to breadboard to computer
+     * Arduino sends packet every 5 sec to breadboard
+     * Breadboard receives packet, reads it, repackages, send to computer
+     * Addresses of xbees are hard coded
+     * Tested
+       * Coordinator to router to router worked
+       * Router to coordinator to router worked
+       * Router to router to router worked
+   * When setting PAN ID, make sure to refresh everything in the networking tab
+   * Programming the arduino
+     * Make sure correct arduino board is selected
+     * Make sure correct port is selected
+     * Make sure xbee shield is in Dline
+   * Programming the breadboard
+     * Make sure arduino pro or pro mini is selected (the one used to bootload the atmega)
+     * Make sure correct port is selected
+     * Make sure Tx and Rx pins aren't connected to anything
+=== To Do ===
+   * Make schematic for bumblebee box
+   * Range testing
+     * "Goal is Bang -> BAM" -Kaeo
+     * Test "Bang -> Boom then Boom -> BAM" -Kaeo
+     * Go through buildings and trees
+   * Start final paper