Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
weatherbox:bumblebee:week_10_-_march_21_2017 [2017/03/24 00:11] kamano |
weatherbox:bumblebee:week_10_-_march_21_2017 [2021/09/19 21:59] (current) |
||
|---|---|---|---|
| Line 18: | Line 18: | ||
| === Updates === | === Updates === | ||
| * Updated gantt chart | * Updated gantt chart | ||
| - | * | + | * Pushed back PCB design and fabrication due to changing focus on networking |
| + | * Will attempt to finish schematic over spring break | ||
| ===Notes=== | ===Notes=== | ||
| Line 26: | Line 27: | ||
| * router to router did not work | * router to router did not work | ||
| * Arduino to breadboard to computer | * Arduino to breadboard to computer | ||
| - | * Coordinator to router to router worked | + | * Arduino sends packet every 5 sec to breadboard |
| - | * Router to coordinator to router worked | + | * Breadboard receives packet, reads it, repackages, send to computer |
| - | * Router to router to router worked | + | * Addresses of xbees are hard coded |
| - | * Setting PAN ID, make sure to refresh everything in the networking tab | + | * Tested |
| - | * | + | * Coordinator to router to router worked |
| + | * Router to coordinator to router worked | ||
| + | * Router to router to router worked | ||
| + | * When setting PAN ID, make sure to refresh everything in the networking tab | ||
| + | * Programming the arduino | ||
| + | * Make sure correct arduino board is selected | ||
| + | * Make sure correct port is selected | ||
| + | * Make sure xbee shield is in Dline | ||
| + | * Programming the breadboard | ||
| + | * Make sure arduino pro or pro mini is selected (the one used to bootload the atmega) | ||
| + | * Make sure correct port is selected | ||
| + | * Make sure Tx and Rx pins aren't connected to anything | ||
| + | === To Do === | ||
| + | * Make schematic for bumblebee box | ||
| + | * Range testing | ||
| + | * "Goal is Bang -> BAM" -Kaeo | ||
| + | * Test "Bang -> Boom then Boom -> BAM" -Kaeo | ||
| + | * Go through buildings and trees | ||
| + | * Start final paper | ||