weatherbox:bumblebee:week_10_-_march_21_2017

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
weatherbox:bumblebee:week_10_-_march_21_2017 [2017/03/24 00:14]
kamano
weatherbox:bumblebee:week_10_-_march_21_2017 [2021/09/19 21:59] (current)
Line 18: Line 18:
 === Updates === === Updates ===
    * Updated gantt chart    * Updated gantt chart
-   +     Pushed back PCB design and fabrication due to changing focus on networking 
 +     * Will attempt to finish schematic over spring break
  
 ===Notes=== ===Notes===
Line 33: Line 34:
        * Router to coordinator to router worked        * Router to coordinator to router worked
        * Router to router to router worked        * Router to router to router worked
-   ​* ​Setting ​PAN ID, make sure to refresh everything in the networking tab+   ​* ​When setting ​PAN ID, make sure to refresh everything in the networking tab
    * Programming the arduino    * Programming the arduino
-     ​* ​make sure +     ​* ​Make sure correct arduino board is selected 
 +     * Make sure correct port is selected 
 +     * Make sure xbee shield is in Dline 
 +   * Programming the breadboard 
 +     * Make sure arduino pro or pro mini is selected (the one used to bootload the atmega) 
 +     * Make sure correct port is selected 
 +     * Make sure Tx and Rx pins aren't connected to anything 
 +=== To Do === 
 +   * Make schematic for bumblebee box 
 +   * Range testing 
 +     * "Goal is Bang -> BAM" -Kaeo 
 +     * Test "Bang -> Boom then Boom -> BAM" -Kaeo 
 +     * Go through buildings and trees  
 +   * Start final paper
  • weatherbox/bumblebee/week_10_-_march_21_2017.1490314489.txt.gz
  • Last modified: 2021/09/19 21:59
  • (external edit)