Differences

This shows you the differences between two versions of the page.

--- weatherbox:bumblebee:week_10_-_october_30_2018 [2018/11/02 00:02]
sjavier [Meeting Minutes October 31, 2018]
+++ weatherbox:bumblebee:week_10_-_october_30_2018 [2021/09/19 21:59] (current)
@@ Line 16: / Line 16: @@
   * Will be working with cranberry's board for deployment
   * Changed the destination address of cranberry's Xbee to relay's serial high and low
+  * Connected a 5V step-down/step-up voltage regulator
+        - Bare Arduino will be connected to solar panel and battery so the voltage going in the board needs to be regulated
 ===To Do===
-  * Ask firmware about cranberry's code to change the address to relay Xbee
+  * Ask firmware where to locate cranberry's code
+        - change the address to relay Xbee
   * Finish preparation for deployment
        - make sure relay Xbee receive packets from cranberry and be able to transmit to gateway
@@ Line 26: / Line 29: @@
 === Updates ===
-  *
+  * Deployment Day
+         - Was able to transmit before closing (taping) the box
+         - After clamping the box, it wasn't transmitting any data - not sure whether it is the Bumblebee or Cranberry's board
+         - Since we ran out of time, we decided not to deploy.
+         - Also decided to hold off on deploying Bumblebee until we have our PCB board ready. Figured out that the connections are not stable since we are using wires.
 ==To Do===
-  *
+  * CDR Presentation on Saturday, November 10
+  * Work on CDR Powerpoint Presentation
+  * Work with Andrew to fix our code
+          - Handling more than one packet