Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
weatherbox:bumblebee:week_11_-_april_1_2019 [2019/04/11 23:42] xchen [Meeting Minutes April 5, 2019] |
weatherbox:bumblebee:week_11_-_april_1_2019 [2021/09/19 21:59] (current) |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ===== Week 11 ===== | ===== Week 11 ===== | ||
| - | ==== Meeting Minutes April 4, 2019 ==== | + | ==== Meeting Minutes April 4 and 5, 2019 ==== |
| - | **Attended: Mizpah, Sharmaine, Xiao** | + | |
| - | + | ||
| - | === Updates === | + | |
| - | * | + | |
| - | + | ||
| - | ===To Do=== | + | |
| - | * | + | |
| - | + | ||
| - | + | ||
| - | ==== Meeting Minutes April 5, 2019 ==== | + | |
| **Attended: Mizpah, Sharmaine, Xiao** | **Attended: Mizpah, Sharmaine, Xiao** | ||
| Line 25: | Line 15: | ||
| * We'll fix our design again so our PCB would run at 5V | * We'll fix our design again so our PCB would run at 5V | ||
| * So far, we know that the sending code works fine. The relay code may or may not be the problem. We'll further work with Firmware to figure out the relay code. | * So far, we know that the sending code works fine. The relay code may or may not be the problem. We'll further work with Firmware to figure out the relay code. | ||
| + | * As a note, our range testing data may not be as accurate as we thought since the measured voltage of the clock and XBee wasn't where we thought it would be. | ||
| ===To Do=== | ===To Do=== | ||
| - | * | + | * Possibly redesign our PCB to run at 5V with the 16MHz clock |
| + | * Work with Firmware on relay code | ||