Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
weatherbox:bumblebee:week_14_-_december_4_2019 [2019/09/09 19:04] ryoung created |
weatherbox:bumblebee:week_14_-_december_4_2019 [2021/09/19 21:59] (current) |
||
|---|---|---|---|
| Line 5: | Line 5: | ||
| === Updates === | === Updates === | ||
| - | * | + | * Sharmaine taught us how to use XCTU properly |
| + | * Tested Bare Bumblebee, fixed some connections | ||
| + | * Final Presentation | ||
| ===To Do=== | ===To Do=== | ||
| * Debug PCB from last semester | * Debug PCB from last semester | ||
| + | * Find correct 5V boost part | ||
| ==== Meeting Minutes December 6, 2019 ==== | ==== Meeting Minutes December 6, 2019 ==== | ||
| Line 13: | Line 16: | ||
| === Updates === | === Updates === | ||
| - | * Configured XBee Pro S2C | + | * Continue learning how to use XCTU for router, relay and transmit XBee |
| - | - Asked Firmware team for help | + | * Continue debugging Bare Bumblebee |
| - | - In XCTU: | + | * Final Presentation |
| - | - Since XCTU couldn't recognize new XBee's, we used Xbee recovery | + | |
| - | - Update firmware to Zigbee protocol | + | |
| - | - Configure 3 XBees: 2 routers and 1 coordinator | + | |
| - | * Continue populating the board | + | |
| ===To Do=== | ===To Do=== | ||
| * Continue debugging old PCB | * Continue debugging old PCB | ||
| + | * Final Report | ||