Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
weatherbox:bumblebee:week_3_-_january_28_2019 [2019/02/02 01:54] sjavier created |
weatherbox:bumblebee:week_3_-_january_28_2019 [2021/09/19 21:59] (current) |
||
|---|---|---|---|
| Line 6: | Line 6: | ||
| === Updates === | === Updates === | ||
| * Continue populating new PCB | * Continue populating new PCB | ||
| - | * Continue debugging PCB: solar chip is not soldered on properly | + | * Continue debugging 2nd PCB: conclusion: solar chip is not soldered on properly |
| - since LEDs are not connected to ground | - since LEDs are not connected to ground | ||
| - solution: resolder solar chip | - solution: resolder solar chip | ||
| ===To Do=== | ===To Do=== | ||
| - | * Continue working on soldering solar chip | + | * resolder solar chip on the second board |
| + | * Finish up populating new board | ||
| ==== Meeting Minutes February 1, 2019 ==== | ==== Meeting Minutes February 1, 2019 ==== | ||
| Line 17: | Line 18: | ||
| === Updates === | === Updates === | ||
| - | * | + | * Resoldered solar chip |
| + | * Debug solar chip | ||
| + | * resoldered but same problems as before | ||
| + | * tried running on the 3rd board. same problems as before | ||
| + | * leaking voltage? | ||
| + | * Kenneth mentioned that their board before had problems with the switch as the switch was leaking voltage into the board. | ||
| + | * we removed the switch and soldered on wires in its place on TX and RX | ||
| ===To Do=== | ===To Do=== | ||
| - | * | + | * Continue Debugging solar chip. |
| + | * Work with Firmware team to debug. | ||