Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
weatherbox:bumblebee:week_4_-_february_4_2019 [2019/02/21 23:10] xchen |
weatherbox:bumblebee:week_4_-_february_4_2019 [2021/09/19 21:59] (current) |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ===== Week 4 ===== | ===== Week 4 ===== | ||
| - | ==== Meeting Minutes February 7, 2019 ==== | + | ==== Meeting Minutes February 6, 2019 ==== |
| - | **Attended: Mizpah, Sharmaine, Xiao** | + | **Attended: Mizpah and Sharmaine** |
| === Updates === | === Updates === | ||
| - | * | + | * Debugging Solar chip |
| ===To Do=== | ===To Do=== | ||
| - | * | + | * continue debugging solar chip |
| - | ==== Meeting Minutes February 8, 2019 ==== | + | ==== Meeting Minutes February 7, 2019 ==== |
| **Attended: Mizpah, Sharmaine, Xiao** | **Attended: Mizpah, Sharmaine, Xiao** | ||
| === Updates === | === Updates === | ||
| - | * | + | * Worked with firmware to debug |
| + | * potential problem with the board | ||
| + | * Firmware | ||
| + | * Firmware helped us debug to see if the functionality of the LED. However, it doesn't seem to go through the loop. | ||
| + | * Solar charger | ||
| + | * it may or may not be soldered on correctly but we can't seem to check as the pads on the bottom of the solar chip. | ||
| + | * Switch leaking as mentioned in previous | ||
| ===To Do=== | ===To Do=== | ||
| - | * | + | * research new ways of what to do |