Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
weatherbox:bumblebee:week_4_-_september_25_2019 [2019/09/09 18:49] ryoung created |
weatherbox:bumblebee:week_4_-_september_25_2019 [2021/09/19 21:59] (current) |
||
|---|---|---|---|
| Line 5: | Line 5: | ||
| === Updates === | === Updates === | ||
| - | * | + | * looking at parts we needed, board problems |
| ===To Do=== | ===To Do=== | ||
| * Debug PCB from last semester | * Debug PCB from last semester | ||
| Line 13: | Line 13: | ||
| === Updates === | === Updates === | ||
| - | * Configured XBee Pro S2C | + | * Debug old PCB |
| - | - Asked Firmware team for help | + | |
| - | - In XCTU: | + | |
| - | - Since XCTU couldn't recognize new XBee's, we used Xbee recovery | + | |
| - | - Update firmware to Zigbee protocol | + | |
| - | - Configure 3 XBees: 2 routers and 1 coordinator | + | |
| - | * Continue populating the board | + | |
| ===To Do=== | ===To Do=== | ||
| * Continue debugging old PCB | * Continue debugging old PCB | ||