Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
weatherbox:bumblebee:week_8_-_october_23_2019 [2019/09/09 19:00] ryoung created |
weatherbox:bumblebee:week_8_-_october_23_2019 [2021/09/19 21:59] (current) |
||
|---|---|---|---|
| Line 5: | Line 5: | ||
| === Updates === | === Updates === | ||
| - | * | + | * accidentally took apart a bare bumblebee that was already made |
| + | * had to redo making a bare bumblebee so we could do range testing | ||
| ===To Do=== | ===To Do=== | ||
| * Debug PCB from last semester | * Debug PCB from last semester | ||
| + | * bare bumblebee | ||
| + | * populate new PCB | ||
| ==== Meeting Minutes October 25, 2019 ==== | ==== Meeting Minutes October 25, 2019 ==== | ||
| Line 13: | Line 16: | ||
| === Updates === | === Updates === | ||
| - | * Configured XBee Pro S2C | + | * Start populating new board |
| - | - Asked Firmware team for help | + | * continue putting together bare bumblebee |
| - | - In XCTU: | + | |
| - | - Since XCTU couldn't recognize new XBee's, we used Xbee recovery | + | |
| - | - Update firmware to Zigbee protocol | + | |
| - | - Configure 3 XBees: 2 routers and 1 coordinator | + | |
| - | * Continue populating the board | + | |
| ===To Do=== | ===To Do=== | ||
| * Continue debugging old PCB | * Continue debugging old PCB | ||
| + | * populate new PCB | ||