Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
weatherbox:guava:week_15_-_april_27_2020 [2020/05/01 00:40] mmochizuki created |
weatherbox:guava:week_15_-_april_27_2020 [2021/09/19 21:59] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== April 16th, 2020 ====== | + | ====== April 30th, 2020 ====== |
- | We spent most of our hours today figuring out how to program ATMEGA 1284P. What we found is that we can do so by using FTDI, we would need to make sure that FTDI is the source that powers and grounds bare Guava. We were able to successfully program the blink test on it and confirm that the ATMEGA 1284P is boot-loaded with the boot-loader we burn in last week or so. But, what we found out is that the reset pinout is not assigned to the correct pin in ATMEGA 1284P, instead, it assigned to pin 1, which is the reset pinout for ATMEGA 328. Also, the pinout we have on the program does not match the output on ATMEGA 1284P. We think this means that the boot-loader we burnt is not correct, we would need to look for a different boot-loader. | + | We spent our lab hours researching on some more weatherbox implementations and sensors. Diwen focused on the commercial solutions available while Riley found more projects that other universities were working on. Max looked into more sensors that we could implement on future designs. |
+ | |||
+ | Next we worked on our final presentation and rehearsed our slides and information that we were presenting. | ||
+ | |||
+ | Everyone individually researched for about two hours outside of lab hours. | ||
Members: Diwen, Riley, Max | Members: Diwen, Riley, Max | ||
- | Time: 3:30PM - 5:30PM | + | Time: 1:00 PM - 3:00 PM |