Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
weatherbox:team_snapdragon:meeting_minutes_february_2_2017 [2017/02/08 00:50] kchan |
weatherbox:team_snapdragon:meeting_minutes_february_2_2017 [2021/09/19 21:59] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ===== 296 Team Meeting - February 2, 2017 ====== | + | ===== 296 Team Meeting (Unofficial) - February 2, 2017 ====== |
**Attended: Kyle, Akira** | **Attended: Kyle, Akira** | ||
Line 6: | Line 6: | ||
* Finished Bare Arduino | * Finished Bare Arduino | ||
+ | * Problems | ||
+ | * (1) Was unable to openthe serial port to program | ||
+ | * (2) Ableto open the port but FTDI programmer was not responding | ||
+ | * Solutions | ||
+ | * (1) Switched out faulty FTDI board | ||
+ | * (2) Realized that reset button has to be pressed after com port is opened | ||
+ | * Improvements | ||
+ | * (1) Got rid of the rest switch on the breadboard | ||
+ | * (2) Tied the FTDI rts port to 10 uF cap in series to the mcu reset pin | ||
+ | * Other notes | ||
+ | * Enable verbose on Arduino IDE while uploading | ||
==== Discussions: ==== | ==== Discussions: ==== | ||
Line 16: | Line 27: | ||
==== Reminders: ==== | ==== Reminders: ==== | ||
- | * Continue sensor testing | + | * Start sensor testing |
* Make Linkedin Accounts | * Make Linkedin Accounts |