Show pageOld revisionsBacklinksBack to top This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong. **Attended: Dante, Kaniela, Brandon, Guanchen ** === Updates === * Completed Two sets of range tests with the Xbee 3s and S2Cs * Spoke with Dr. Kuh and discussed progress * Created the new Bumblebee Inner and Outer housing -> V3.0 housing and updated to V3.1 * 3D printed both iterations of Inner housing * Updated Gantt Chart ===To Do=== * Setup New Xbee 3 pro as coordinator and router * Try to collab with hardware team to do range testing with real data * Continue to research and test housing + 3D printing -> Will change roof design of Outer housing * Current idea to use Waterproof tape for antenna hole and 'Straw star hole' design for bottom hole weatherbox/bumblebee/week_6_-_february_26_2025.txt Last modified: 2025/02/27 02:44by kanielap